Damaged handle cable or rod.
My inner handle wont open the door.
If the set screw on the handle is stripped and difficult to tighten replace it with a new one.
If this is the problem clean the paint off.
Remove the inner door handle.
Door knob turns but won t open.
To fix the door knob figure out where the connections have gone awry.
If you have the tools and skills you need to take the panel out from the doors inside so you can get access to the mechanical elements of the car door.
When the lock is at rest the spring is fully extended.
Use a tool a flathead screwdriver will work to twist within the gap the thru spindle inserts into.
However a spinning knob or handle means something is wrong with your.
Some models have handles that have no screw but are held on by locks which are disengaged by sliding the bezel either forward or back.
See if this retracts the handle.
Paint on the edge of the door sometimes prevents the barrel from retracting.
Here is the wayt to check if you need anything just let me know.
A knob or a handle typically uses a spring loaded latch to function.
If the inner handle isn t placed properly and fit exactly into place it will also create problems and fail to open even if the inner door clip is not broken.
Remove inside handle bezel.
Look for a screw in the bezel under the handle lever.
Tape the screwdriver tip before use.
Using a screwdriver remove the inside handle bezel as shown in the illustration.
Check to make sure the handle is not broken.
Using a screwdriver open the cover.
1998 toyota 4runner limited 4x4 black.
Issues with the rods or door handle cables can also trigger your car door from not opening.
Lubricating the door latch is one of the ways in which doors that won t open from the inside or the outside can be fixed.
Begin by checking the keyway for blockage.
Remove the handles including the thru spindle.
If the cable or rod that connects the door handle to the latch assembly is damaged or has come loose the door will not open.
Next open the door and try to adjust the lock assembly to see what is stuck.
This is usually only on one side either the inside handle won t open the door or the outside handle won t open the door but the other one will work fine.
Lubricate the assembly and move again.
There should be a cable or rod attached to the handle.
When you turn the knob or handle the spring should compress and open the lock allowing you to open your door.
