With the door propped open take the s hook out of the support and tighten or loosen the cable as needed.
My garage door opens crooked.
One question some homeowners ask is why their garage door closes then immediately reverses to the open position.
By pushing the door back into position you should have made the vertical track straighten.
It is possible that the vertical track down the side has gone out of alignment and shifted due to a slightly loose lag screw.
5adjust the lift cable.
Your garage door is likely the largest opening on your home s exterior so it s important to have the peace of mind that it is functioning properly.
Any of these situations indicate that one or both garage door tracks need to be aligned.
A garage door that s out of alignment can be very dangerous.
If the opener is adjusted properly the garage door will move up and down in an even motion.
If your garage door is closing fully and then reversing to open again then it may be due to a problem with the close limit switch.
A crooked or off balanced door.
Warping of the door will also cause it to run crooked and stick in the tracks.
Garage doors which have become crooked or wonky may be suffering from jumped cables which is when one or both cables have loosened from the cable drums and started to unwind.
This will cause the unit to stick.
There may be a large gap of space between the stop molding and the door.
In order to fix this you ll want to make small changes to the close limit setting until the door opener knows to stop once the door has reached the floor.
The cable is attached to the door and runs to an s hook that attaches to the track support.
Your garage door has two overhead springs some doors have the springs on the side called extension springs that are responsible for opening and closing the door.
The door might be hard to open and close due to it binding.
Why does my garage door reverse as soon as it hits the floor.
Here are three possibilities.
Without proper adjustment however the unit may run along the tracks unevenly.
Jumped cables can be caused by the door hitting an object during operation or if it has been lifted too fast while being opened manually.
Push the door push the door back to adjust the door and get the center aligned again.
